CHAPTER 6 - Removing OpenSpand from its case without damagine it.

You will rarely or never have to remove OpenSpand from its case, however it is required to:

• replace the real time clock battery
• access the PICO USB-C connector to update firmware
• setting 5 volt connections for certain joystick and game controllers
• set if the video output is terminated with a 75 ohm resistor

For details on each of the above read CHAPTER 6a

There is one tricky part to opening the OpenSpand case without damaging it so I strongly urge you to watch this 5-minute video before doing so.

In addition, the following precautions are advised:

1. Perform this operation seated at a clear area on a table to avoid dropping any small screws, your 2mm Allen Wrench, or header jumpers.
2. Static electricity can damage electronic components, even when they are not plugged in.  Don't open the case in a high static electricty producing environmnet such as in a very dry room or wearing a wool sweater.
   
   
   

7 minute video: How to remove OpenSpand board from its case.